ASTM WK35053

    New Test Method for Dried and Fired Permanent Linear Change of Refractory Castables

    (What is a Work Item?)

    Developed by Subcommittee: C08.09 | Committee C08 | Contact Staff Manager



    WK35053

    1. Scope

    1.1 This test method covers the determination of the drying and firing permanent linear change of refractory castables under laboratory conditions. 1.2 This test method may not apply to refractory castables with a density of less than 40 psi or materials with a linear change of greater than 3 %. 1.3 Units-The values in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    Linear change is a commonly measured and specified property of refractory castables.


    Keywords

    refractory; castable; permanent linear change; firing

    The title and scope are in draft form and are under development within this ASTM Committee.

    Citing ASTM Standards
    Back to Top
    Work Item Status

    Date Initiated:
    10-27-2011

    Technical Contact:
    Benjamin Markel

    Status:
    Draft Under Development