ASTM WK30297

    New Practice for Utilization of Mobile, Automated Cured-in-Place Pipe Manufacturing Systems

    (What is a Work Item?)

    Developed by Subcommittee: F17.67 | Committee F17 | Contact Staff Manager


    1. Scope

    1.1 This practice describes the procedures for the manufacture of cured-in-place pipe using state-of-the-art, mobile, automated systems. Once resin saturation is complete, the wet out liner is then used to rehabilitate existing gravity flow or pressure pipelines, process piping, electrical conduits, or ventilation systems. 1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    automation; epoxy

    The title and scope are in draft form and are under development within this ASTM Committee.

    Citing ASTM Standards
    Back to Top
    Work Item Status

    Date Initiated:

    Technical Contact:
    David Kozman

    Draft Under Development