ASTM WK11340

    New Test Method for Determination of Sediment Control Products Ability to Reduce Soil Loss Associated With Rainfall-Induced Erosion

    (What is a Work Item?)

    Developed by Subcommittee: D18.25 | Committee D18 | Contact Staff Manager


    1. Scope

    1.1 This test method covers the guidelines, requirements, and procedures for evaluating the ability of sediment control products (SCPs) to reduce soil loss from rainfall-induced erosion. Critical elements of this reduction are the ability of the SCP to: 1.1.1 Slow runoff and catch sediment particles before exiting the slope and 1.1.2 Encourage infiltration, thereby reducing soil particle displacement and transport through overland flow mechanisms. 1.2 This test method uses full-scale testing procedures rather than reduced-scale (bench-scale) simulation and is patterned after conditions typically found on construction sites. 1.3 This test method provides a comparative evaluation of an SCP to baseline bare soil conditions under controlled and documented conditions. 1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information purposes only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Also, the user must comply with prevalent regulatory codes, such as OSHA (Occupational Health and Safety Administration) guidelines, while using this test method.


    SCP; sediment control product; rainfall simulation; runoff; sediment; soil loss


    This standard is needed to test the ability of sediment control products to reduce soil loss generated by rainfall-induced erosion. It will be used to specify products on job sites and to differentiate similar products. It will be used by engineers, DOTs, and county and city workers to place properly the correct product in the correct application.

    The title and scope are in draft form and are under development within this ASTM Committee.

    Citing ASTM Standards
    Back to Top
    Work Item Status

    Date Initiated:

    Technical Contact:
    Derrold Foster

    Draft Under Development