Standard Withdrawn, Replaced Replaced By: F450    Last Updated: Sep 12, 2011 Track Document
ASTM F595-01(2005)

Standard Test Methods for Vacuum Cleaner Hose—Durability and Reliability (All-Plastic Hose)

Standard Test Methods for Vacuum Cleaner Hose—Durability and Reliability (All-Plastic Hose) F0595-01R05 ASTM|F0595-01R05|en-US Standard Test Methods for Vacuum Cleaner Hose—Durability and Reliability (All-Plastic Hose) Standard new BOS Vol. 15.08 Committee F11
$ 0.00 Out of stock

Significance and Use

These test methods can be used by buyers of vacuum cleaner hose to specify the test criteria the hose must meet to be acceptable for their purposes.

Scope

1.1 These test methods cover the determination of the effect of anticipated stresses and strains that vacuum cleaner hoses will receive in normal use.

1.2 These test methods apply to all-plastic, nonelectric vacuum cleaner hoses for household use.

Note 1—For information on plastic wire-reinforced, nonelectric vacuum cleaner hoses for household use, refer to Test Method F 450.

1.3 These test methods are individual tests as agreed upon between the hose manufacturer and the vacuum cleaner manufacturer.

1.4 The following tests are included:

Section
Torsional flex6
Hot and cold flex with aging (optional)7
Abrasion (external surface) (optional)8
Flex9
Pull test on hose fittings with aging10
Crush11

1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathmatical conversions to SI units, which are provided for information only and are not considered standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Language unavailable
Format unavailable
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center