| ||Format||Pages||Price|| |
|11||$62.40||  ADD TO CART|
Formerly under the jurisdiction of Committee D13 on Textiles, this test method was withdrawn in February 2008 in accordance with section 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.
1.1 This test method is used to measure the vertical flame resistance of textiles.
1.1.1 As a part of the meaure of flame resistance, afterflame and afterglow characteristics are evaluated.
1.2 This standard shall be used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled laboratory conditions and shall not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions.
1.3 The values stated in either SI units or other units are to be regarded separately. The values stated in each system are not exact equivalents; therefore, each system shall be used independently without combining values.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D123 Terminology Relating to Textiles
D1776 Practice for Conditioning and Testing Textiles
D4391 Terminology Relating to The Burning Behavior of Textiles
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D6413-, Standard Test Method for Flame Resistance of Textiles (Vertical Test) (Withdrawn 2008), ASTM International, West Conshohocken, PA, 1999, www.astm.orgBack to Top