Standard Withdrawn, No replacement   Last Updated: Dec 31, 2010 Track Document
ASTM D5908-96(2004)

Standard Test Method for Resin Binder Distribution and Binder Penetration Analysis of Polyester Nonwoven Fabrics (Withdrawn 2008)

Standard Test Method for Resin Binder Distribution and Binder Penetration Analysis of Polyester Nonwoven Fabrics (Withdrawn 2008) D5908-96R04 ASTM|D5908-96R04|en-US Standard Test Method for Resin Binder Distribution and Binder Penetration Analysis of Polyester Nonwoven Fabrics (Withdrawn 2008) Standard new BOS Vol. 07.02 Committee D13
$ 0.00 Out of stock

Significance and Use

This test method is used in the trade for acceptance testing of commercial shipments.

5.1.1 In case of a dispute arising from differences in reported test results when using this test method, the purchaser and the supplier should conduct comparative tests to determine if there is a statistical bias between their laboratories. Competent statistical assistance is recommended for the investigation of bias. As a minimum, the two parties should take a group of test samples that are as homogeneous as possible and are from a material lot of the type in question. The test samples should then be randomly assigned in equal numbers to each laboratory for testing. The average results from the two laboratories should be compared using a statistical test for unpaired data and an acceptable probability level chosen by the two parties before the testing is begun. If a bias is found, either its cause must be found and corrected or the purchaser and the supplier must agree to interpret future test results with consideration of the known bias.

This test method is used to assess the distribution of resin binder application. The distribution of resin binder relates to batting performance.

Scope

1.1 This test method covers the analysis of polyester highloft nonwoven fabrics for resin binder distribution and binder penetration.

1.2 The values stated in SI units are to be regarded as the standard. The inch-pound values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Language unavailable
Format unavailable
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center