Standard Withdrawn, No replacement   Last Updated: Feb 19, 2016 Track Document
ASTM D2822/D2822M-05(2011)e1

Standard Specification for Asphalt Roof Cement, Asbestos Containing (Withdrawn 2016)

Standard Specification for Asphalt Roof Cement, Asbestos Containing (Withdrawn 2016) D2822_D2822M-05R11E01 ASTM|D2822_D2822M-05R11E01|en-US Standard Specification for Asphalt Roof Cement, Asbestos Containing (Withdrawn 2016) Standard new BOS Vol. 04.04 Committee D08
$ 0.00 Out of stock

Abstract

This specification covers the requirements for two types and two classes of asbestos-containing asphalt roof cement consisting of an asphalt base, volatile petroleum solvents, and mineral stabilizers including asbestos fiber, mixed to a smooth, uniform consistency suitable for trowel application to roofing and flashing. Type I is made from asphalts characterized as self-healing, adhesive, and ductile, while Type II is made from asphalt characterized by high softening point and relatively low ductility. Class I is used for application to essentially dry surfaces, while Class II is used for application to damp, wet, or underwater surfaces. The cements shall meet specified composition limits of water, nonvolatile matter, asbestos and other mineral stabilizers, asphalt, and mineral matter based on original mass of insoluble residue. They shall also conform to physical requirements such as uniformity, workability, pliability and behavior at given temperatures, and adhesion to damp, wet, or underwater surfaces.

Scope

1.1 This specification covers asbestos-containing asphalt roof cement used for trowel application to roofings and flashings.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 The following safety hazards caveat pertains only to the test methods described in this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Language unavailable
Format unavailable
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center