| ||Format||Pages||Price|| |
|6||$60.00||  ADD TO CART|
This test method covers the determination of turbidity in water and wastewater. Formerly under the jurisdiction of Committee D19 on Water, this specification was withdrawn in June 2007 and replaced by Test Method D 6698 for On-Line Measurement of Turbidity Below 5 NTU in Water and Test Method D 6855 for Determination of Turbidity Below 5 NTU in Static Mode.
For referenced ASTM standards, visit the ASTM website, www.astm.org, or contact ASTM Customer Service at firstname.lastname@example.org. For Annual Book of ASTM Standards volume information, refer to the standard's Document Summary page on the ASTM website.
1.1 This test method covers the determination of turbidity in water and wastewater.
1.2 This test method is applicable to the measurement of turbidities in the range from 1.0 to 40 nephelometric turbidity units (NTU).
1.3 Higher turbidities may be measured using this test method by serial dilution to applicable range.
1.4 This test method was tested on municipal drinking water and final effluent discharges. It is the user's responsibility to ensure the validity of this test method for waters of untested matrices.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Refer to all material safety data sheets (MSDS) prior to preparing or using standards and before calibrating or performing instrument maintenance.
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D1889-00, Standard Test Method for Turbidity of Water (Withdrawn 2007), ASTM International, West Conshohocken, PA, 2000, www.astm.orgBack to Top