ASTM F899 - 12b Standard Specification for Wrought Stainless Steels for Surgical Instruments

    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    F116 Standard Specification for Medical Screwdriver Bits

    F921 Standard Terminology Relating to Hemostatic Forceps

    F1026 Standard Specification for General Workmanship and Performance Measurements of Hemostatic Forceps

    F1078 Standard Terminology for Surgical Scissors—Inserted and Non-Inserted Blades

    F1079 Standard Specification for Inserted and Noninserted Surgical Scissors

    F1089 Standard Test Method for Corrosion of Surgical Instruments

    F1325 Standard Specification for Stainless Steel Suture Needle Holders-General Workmanship Requirements and Corresponding Test Methods

    F1611 Standard Specification for Intramedullary Reamers

    F1613 Standard Specification for Surgical Tissue/Dressing/Pick-Up Forceps (Thumb Type)

    F1638 Standard Terminology for Surgical Tissue/Dressing/Pick-Up Forceps (Thumb-Type)

    F1744 Standard Guide for Care and Handling of Stainless Steel Surgical Instruments

    F2062 Standard Specification for Square Drive Interconnections on Surgical Instruments

    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    A276 Specification for Stainless Steel Bars and Shapes

    A313/A313M Specification for Stainless Steel Spring Wire

    A314 Specification for Stainless Steel Billets and Bars for Forging

    A480/A480M Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and Strip

    A484/A484M Specification for General Requirements for Stainless Steel Bars, Billets, and Forgings

    A555/A555M Specification for General Requirements for Stainless Steel Wire and Wire Rods

    A564/A564M Specification for Hot-Rolled and Cold-Finished Age-Hardening Stainless Steel Bars and Shapes

    A582/A582M Specification for Free-Machining Stainless Steel Bars

    A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products