ASTM F602 - 09(2015) Standard Criteria for Implantable Thermoset Epoxy Plastics

    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    F641 Standard Specification for Implantable Epoxy Electronic Encapsulants

    F2027 Standard Guide for Characterization and Testing of Raw or Starting Materials for Tissue-Engineered Medical Products

    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    D149 Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies

    D150 Test Methods for AC Loss Characteristics and Permittivity (Dielectric Constant) of Solid Electrical Insulation

    D257 Test Methods for DC Resistance or Conductance of Insulating Materials

    D570 Test Method for Water Absorption of Plastics

    D621 Test Methods for Deformation of Plastics Under Load

    D638 Test Method for Tensile Properties of Plastics

    D785 Test Method for Rockwell Hardness of Plastics and Electrical Insulating Materials

    D792 Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement

    D952 Test Method for Bond or Cohesive Strength of Sheet Plastics and Electrical Insulating Materials

    D1042 Test Method for Linear Dimensional Changes of Plastics Caused by Exposure to Heat and Moisture

    D1434 Test Method for Determining Gas Permeability Characteristics of Plastic Film and Sheeting

    D1763 Specification for Epoxy Resins

    D2393 Test Method for Viscosity of Epoxy Resins and Related Components

    D2471 Practice for Gel Time and Peak Exothermic Temperature of Reacting Thermosetting Resins

    D2562 Practice for Classifying Visual Defects in Parts Molded from Reinforced Thermosetting Plastics

    D2734 Test Methods for Void Content of Reinforced Plastics

    D3137 Test Method for Rubber Property--Hydrolytic Stability

    E96/E96M Test Methods for Water Vapor Transmission of Materials

    F74 Practice for Determining Hydrolytic Stability of Plastic Encapsulants for Electronic Devices

    F619 Practice for Extraction of Medical Plastics

    F748 Practice for Selecting Generic Biological Test Methods for Materials and Devices