ASTM F2437 / F2437M - 17 Standard Specification for Carbon and Alloy Steel Compressible-Washer-Type Direct Tension Indicators for Use with Cap Screws, Bolts, Anchors, and Studs


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    There are currently no referencing documents for this standard.


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    A193/A193M Specification for Alloy-Steel and Stainless Steel Bolting for High Temperature or High Pressure Service and Other Special Purpose Applications

    A194/A194M Specification for Carbon Steel, Alloy Steel, and Stainless Steel Nuts for Bolts for High Pressure or High Temperature Service, or Both

    A307 Specification for Carbon Steel Bolts, Studs, and Threaded Rod 60 000 PSI Tensile Strength

    A354 Specification for Quenched and Tempered Alloy Steel Bolts, Studs, and Other Externally Threaded Fasteners

    A449 Specification for Hex Cap Screws, Bolts and Studs, Steel, Heat Treated, 120/105/90 ksi Minimum Tensile Strength, General Use

    A563 Specification for Carbon and Alloy Steel Nuts

    B695 Specification for Coatings of Zinc Mechanically Deposited on Iron and Steel

    F436/F436M Specification for Hardened Steel Washers Inch and Metric Dimensions

    F606/F606M Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets

    F1470 Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection

    F1554 Specification for Anchor Bolts, Steel, 36, 55, and 105-ksi Yield Strength

    F1789 Terminology for F16 Mechanical Fasteners

    F1941/F1941M Specification for Electrodeposited Coatings on Mechanical Fasteners, Inch and Metric