ASTM F2328M - 17 Standard Test Method for Determining Decarburization and Carburization in Hardened and Tempered Threaded Steel Bolts, Screws, Studs, and Nuts (Metric)

    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    A962/A962M Standard Specification for Common Requirements for Bolting Intended for Use at Any Temperature from Cryogenic to the Creep Range

    F606/F606M Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets

    F2882/F2882M Standard Specification for Screws, Alloy Steel, Heat Treated, 170 ksi and 1170 MPa Minimum Tensile Strength (Inch and Metric)

    F3125/F3125M Standard Specification for High Strength Structural Bolts, Steel and Alloy Steel, Heat Treated, 120 ksi (830 MPa) and 150 ksi (1040 MPa) Minimum Tensile Strength, Inch and Metric Dimensions

    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    A574M Specification for Alloy Steel Socket-Head Cap Screws (Metric)

    E3 Guide for Preparation of Metallographic Specimens

    E384 Test Method for Microindentation Hardness of Materials

    F835M Specification for Alloy Steel Socket Button and Flat Countersunk Head Cap Screws (Metric)

    F912M Specification for Alloy Steel Socket Set Screws (Metric)

    F1789 Terminology for F16 Mechanical Fasteners