ASTM F22 - 13(2021) Standard Test Method for Hydrophobic Surface Films by the Water-Break Test

    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    A380/A380M Standard Practice for Cleaning, Descaling, and Passivation of Stainless Steel Parts, Equipment, and Systems

    D2510 Standard Test Method for Adhesion of Solid Film Lubricants

    D2625 Standard Test Method for Endurance (Wear) Life and Load-Carrying Capacity of Solid Film Lubricants (Falex Pin and Vee Method)

    F21 Standard Test Method for Hydrophobic Surface Films by the Atomizer Test

    F2661 Standard Test Method for Determining the Tribological Behavior and the Relative Lifetime of a Fluid Lubricant using the Spiral Orbit Tribometer

    F2664 Standard Guide for Assessing the Attachment of Cells to Biomaterial Surfaces by Physical Methods

    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    C813 Test Method for Hydrophobic Contamination on Glass by Contact Angle Measurement

    D351 Classification for Natural Muscovite Block Mica and Thins Based on Visual Quality

    D1193 Specification for Reagent Water

    D2578 Test Method for Wetting Tension of Polyethylene and Polypropylene Films

    D5946 Test Method for Corona-Treated Polymer Films Using Water Contact Angle Measurements

    D7334 Practice for Surface Wettability of Coatings, Substrates and Pigments by Advancing Contact Angle Measurement

    D7490 Test Method for Measurement of the Surface Tension of Solid Coatings, Substrates and Pigments using Contact Angle Measurements

    F21 Test Method for Hydrophobic Surface Films by the Atomizer Test