ASTM F1290 - 19 Standard Practice for Electrofusion Joining Polyolefin Pipe and Fittings

---

Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

E3167/E3167M Standard Practice for Conventional Pulse-Echo Ultrasonic Testing of Polyethylene Electrofusion Joints

E3170/E3170M Standard Practice for Phased Array Ultrasonic Testing of Polyethylene Electrofusion Joints

F645 Standard Guide for Selection, Design, and Installation of Thermoplastic Water- Pressure Piping Systems

F894 Standard Specification for Polyethylene (PE) Large Diameter Profile Wall Sewer and Drain Pipe

F1412 Standard Specification for Polyolefin Pipe and Fittings for Corrosive Waste Drainage Systems

F1901 Standard Specification for Polyethylene (PE) Pipe and Fittings for Roof Drain Systems

F2623 Standard Specification for Polyethylene of Raised Temperature (PE-RT) Systems for Non-Potable Water Applications

F2769 Standard Specification for Polyethylene of Raised Temperature (PE-RT) Plastic Hot and Cold-Water Tubing and Distribution Systems

F2807 Standard Specification for Multilayer Polyethylene-Polyamide (PE-PA) Pipe for Pressure Piping Applications

F3123 Standard Specification for Metric Outside Diameter Polyethylene (PE) Plastic Pipe (DR-PN)

F3371 Standard Specification for Polyolefin Pipe and Fittings for Drainage, Waste, and Vent Applications

---

Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

D1600 Terminology for Abbreviated Terms Relating to Plastics

F412 Terminology Relating to Plastic Piping Systems

F1055 Specification for Electrofusion Type Polyethylene Fittings for Outside Diameter Controlled Polyethylene and Crosslinked Polyethylene (PEX) Pipe and Tubing