ASTM E563 - 11(2016) Standard Practice for Preparation and Use of an Ice-Point Bath as a Reference Temperature

    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    D61 Standard Test Method for Softening Point of Pitches (Cube-in-Water Method)

    D445 Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity)

    D2162 Standard Practice for Basic Calibration of Master Viscometers and Viscosity Oil Standards

    D2532 Standard Test Method for Viscosity and Viscosity Change After Standing at Low Temperature of Aircraft Turbine Lubricants

    D2726/D2726M Standard Test Method for Bulk Specific Gravity and Density of Non-Absorptive Compacted Asphalt Mixtures

    D3829 Standard Test Method for Predicting the Borderline Pumping Temperature of Engine Oil

    D4684 Standard Test Method for Determination of Yield Stress and Apparent Viscosity of Engine Oils at Low Temperature

    D4693 Standard Test Method for Low-Temperature Torque of Grease-Lubricated Wheel Bearings

    D6821 Standard Test Method for Low Temperature Viscosity of Drive Line Lubricants in a Constant Shear Stress Viscometer

    D6896 Standard Test Method for Determination of Yield Stress and Apparent Viscosity of Used Engine Oils at Low Temperature

    D7175 Standard Test Method for Determining the Rheological Properties of Asphalt Binder Using a Dynamic Shear Rheometer

    D7552 Standard Test Method for Determining the Complex Shear Modulus (G*) Of Bituminous Mixtures Using Dynamic Shear Rheometer

    D7962 Standard Practice for Determination of Minimum Immersion Depth and Assessment of Temperature Sensor Measurement Drift

    E1 Standard Specification for ASTM Liquid-in-Glass Thermometers

    E207 Standard Test Method for Thermal EMF Test of Single Thermoelement Materials by Comparison with a Reference Thermoelement of Similar EMF-Temperature Properties

    E220 Standard Test Method for Calibration of Thermocouples By Comparison Techniques

    E452 Standard Test Method for Calibration of Refractory Metal Thermocouples Using a Radiation Thermometer

    E601 Standard Guide for Measuring Electromotive Force (emf) Stability of Base-Metal Thermoelement Materials with Time in Air

    E644 Standard Test Methods for Testing Industrial Resistance Thermometers

    E879 Standard Specification for Thermistor Sensors for General Purpose and Laboratory Temperature Measurements

    E2251 Standard Specification for Liquid-in-Glass ASTM Thermometers with Low-Hazard Precision Liquids

    E2593 Standard Guide for Accuracy Verification of Industrial Platinum Resistance Thermometers

    E2730 Standard Practice for Calibration and Use of Thermocouple Reference Junction Probes in Evaluation of Electronic Reference Junction Compensation Circuits

    E2820 Standard Test Method for Evaluating Thermal EMF Properties of Base-Metal Thermocouple Connectors

    E2846 Standard Guide for Thermocouple Verification

    E2877 Standard Guide for Digital Contact Thermometers

    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    D1193 Specification for Reagent Water

    E344 Terminology Relating to Thermometry and Hydrometry

    E1594 Guide for Expression of Temperature