ASTM E2877 - 12(2019) Standard Guide for Digital Contact Thermometers


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    D61 Standard Test Method for Softening Point of Pitches (Cube-in-Water Method)

    D97 Standard Test Method for Pour Point of Petroleum Products

    D942 Standard Test Method for Oxidation Stability of Lubricating Greases by the Oxygen Pressure Vessel Method

    D943 Standard Test Method for Oxidation Characteristics of Inhibited Mineral Oils

    D1310 Standard Test Method for Flash Point and Fire Point of Liquids by Tag Open-Cup Apparatus

    D2158 Standard Test Method for Residues in Liquefied Petroleum (LP) Gases

    D2162 Standard Practice for Basic Calibration of Master Viscometers and Viscosity Oil Standards

    D2500 Standard Test Method for Cloud Point of Petroleum Products and Liquid Fuels

    D2532 Standard Test Method for Viscosity and Viscosity Change After Standing at Low Temperature of Aircraft Turbine Lubricants

    D2595 Standard Test Method for Evaporation Loss of Lubricating Greases Over Wide-Temperature Range

    D2893 Standard Test Methods for Oxidation Characteristics of Extreme-Pressure Lubrication Oils

    D3934 Standard Test Method for Flash/No Flash Test—Equilibrium Method by a Closed-Cup Apparatus

    D3941 Standard Test Method for Flash Point by the Equilibrium Method With a Closed-Cup Apparatus

    D4171 Standard Specification for Fuel System Icing Inhibitors

    D4539 Standard Test Method for Filterability of Diesel Fuels by Low-Temperature Flow Test (LTFT)

    D5298 Standard Test Method for Measurement of Soil Potential (Suction) Using Filter Paper

    D5853 Standard Test Method for Pour Point of Crude Oils

    D6371 Standard Test Method for Cold Filter Plugging Point of Diesel and Heating Fuels

    D6780/D6780M Standard Test Methods for Water Content and Density of Soil In situ by Time Domain Reflectometry (TDR)

    D7295 Standard Practice for Sampling Combustion Effluents and Other Stationary Sources for the Subsequent Determination of Hydrogen Cyanide

    D8164 Standard Guide for Digital Contact Thermometers for Petroleum Products, Liquid Fuels, and Lubricant Testing

    D8278 Standard Specification for Digital Contact Thermometers for Test Methods Measuring Flow Properties of Fuels and Lubricants

    D8292 Standard Test Method for Permanent Deformation Behavior and Rutting Resistance of Compacted Asphalt Mix in the Modified Loaded Wheel Tracker Test Utilizing Controlled Confining Pressure

    E100 Standard Specification for ASTM Hydrometers

    E1640 Standard Test Method for Assignment of the Glass Transition Temperature By Dynamic Mechanical Analysis


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    E230/E230M Specification for Temperature-Electromotive Force (emf) Tables for Standardized Thermocouples

    E344 Terminology Relating to Thermometry and Hydrometry

    E563 Practice for Preparation and Use of an Ice-Point Bath as a Reference Temperature

    E644 Test Methods for Testing Industrial Resistance Thermometers

    E839 Test Methods for Sheathed Thermocouples and Sheathed Thermocouple Cable

    E879 Specification for Thermistor Sensors for General Purpose and Laboratory Temperature Measurements

    E1137/E1137M Specification for Industrial Platinum Resistance Thermometers

    E2593 Guide for Accuracy Verification of Industrial Platinum Resistance Thermometers

    E2846 Guide for Thermocouple Verification