ASTM D7436 - 17 Standard Classification System for Unfilled Polyethylene Plastics Molding and Extrusion Materials with a Fractional Melt Index Using ISO Protocol and Methodology

---

Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

E3152 Standard Guide for Standard Test Methods and Practices Available for Determining Antifungal Activity on Natural or Synthetic Substrates Treated with Antimicrobial Agents

---

Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

D883 Terminology Relating to Plastics

D1248 Specification for Polyethylene Plastics Extrusion Materials for Wire and Cable

D1600 Terminology for Abbreviated Terms Relating to Plastics

D1693 Test Method for Environmental Stress-Cracking of Ethylene Plastics

D2565 Practice for Xenon-Arc Exposure of Plastics Intended for Outdoor Applications

D3350 Specification for Polyethylene Plastics Pipe and Fittings Materials

D3763 Test Method for High Speed Puncture Properties of Plastics Using Load and Displacement Sensors

D3892 Practice for Packaging/Packing of Plastics

D4000 Classification System for Specifying Plastic Materials

D4329 Practice for Fluorescent Ultraviolet (UV) Lamp Apparatus Exposure of Plastics

D4703 Practice for Compression Molding Thermoplastic Materials into Test Specimens, Plaques, or Sheets

D4976 Specification for Polyethylene Plastics Molding and Extrusion Materials

D6436 Guide for Reporting Properties for Plastics and Thermoplastic Elastomers

D7209 Guide for Waste Reduction, Resource Recovery, and Use of Recycled Polymeric Materials and Products

E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications