ASTM D2170 / D2170M - 18 Standard Test Method for Kinematic Viscosity of Asphalts


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    D88 Standard Test Method for Saybolt Viscosity

    D445 Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity)

    D1754/D1754M Standard Test Method for Effects of Heat and Air on Asphaltic Materials (Thin-Film Oven Test)

    D2026/D2026M Standard Specification for Cutback Asphalt (Slow-Curing Type)

    D2027/D2027M Standard Specification for Cutback Asphalt (Medium-Curing Type)

    D2028/D2028M Standard Specification for Cutback Asphalt (Rapid-Curing Type)

    D2493/D2493M Standard Practice for Viscosity-Temperature Chart for Asphalt Binders

    D3381/D3381M Standard Specification for Viscosity-Graded Asphalt Binder for Use in Pavement Construction

    D3666 Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials

    D3791/D3791M Standard Practice for Evaluating the Effects of Heat on Asphalts

    D4552/D4552M Standard Practice for Classifying Hot-Mix Recycling Agents

    D5505 Standard Practice for Classifying Emulsified Recycling Agents

    D5710/D5710M Standard Specification for Trinidad Lake Modified Asphalt

    D6373 Standard Specification for Performance Graded Asphalt Binder

    D6626 Standard Specification for Performance Graded Trinidad Lake Modified Asphalt Binder

    D7175 Standard Test Method for Determining the Rheological Properties of Asphalt Binder Using a Dynamic Shear Rheometer

    D8239 Standard Specification for Performance-Graded Asphalt Binder Using the Multiple Stress Creep and Recovery (MSCR) Test


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    C670 Practice for Preparing Precision and Bias Statements for Test Methods for Construction Materials

    D8 Terminology Relating to Materials for Roads and Pavements

    D92 Test Method for Flash and Fire Points by Cleveland Open Cup Tester

    D341 Practice for Viscosity-Temperature Charts for Liquid Petroleum Products

    D445 Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity)

    D446 Specifications and Operating Instructions for Glass Capillary Kinematic Viscometers

    D2162 Practice for Basic Calibration of Master Viscometers and Viscosity Oil Standards

    D2493/D2493M Practice for Viscosity-Temperature Chart for Asphalt Binders

    D3666 Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials

    E1 Specification for ASTM Liquid-in-Glass Thermometers

    E77 Test Method for Inspection and Verification of Thermometers

    E879 Specification for Thermistor Sensors for General Purpose and Laboratory Temperature Measurements

    E1137/E1137M Specification for Industrial Platinum Resistance Thermometers