ASTM C144 - 11 Standard Specification for Aggregate for Masonry Mortar

    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    C270 Standard Specification for Mortar for Unit Masonry

    C387/C387M Standard Specification for Packaged, Dry, Combined Materials for Concrete and High Strength Mortar

    C398 Standard Practice for Use of Hydraulic Cement Mortars in Chemical-Resistant Masonry

    C404 Standard Specification for Aggregates for Masonry Grout

    C627 Standard Test Method for Evaluating Ceramic Floor Tile Installation Systems Using the Robinson-Type Floor Tester

    C887 Standard Specification for Packaged, Dry, Combined Materials for Surface Bonding Mortar

    C1142 Standard Specification for Extended Life Mortar for Unit Masonry

    C1180 Standard Terminology of Mortar and Grout for Unit Masonry

    C1314 Standard Test Method for Compressive Strength of Masonry Prisms

    C1324 Standard Test Method for Examination and Analysis of Hardened Masonry Mortar

    C1384 Standard Specification for Admixtures for Masonry Mortars

    C1586 Standard Guide for Quality Assurance of Mortars

    C1660 Standard Specification for Thin-bed Mortar for Autoclaved Aerated Concrete (AAC) Masonry

    C1693 Standard Specification for Autoclaved Aerated Concrete (AAC)

    C1713 Standard Specification for Mortars for the Repair of Historic Masonry

    C1714/C1714M Standard Specification for Preblended Dry Mortar Mix for Unit Masonry

    E754 Standard Test Method for Pullout Resistance of Ties and Anchors Embedded in Masonry Mortar Joints

    E2992/E2992M Standard Test Method for Evaluating Response Robot Mobility: Traverse Sand Terrain

    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    C40 Test Method for Organic Impurities in Fine Aggregates for Concrete

    C87 Test Method for Effect of Organic Impurities in Fine Aggregate on Strength of Mortar

    C88 Test Method for Soundness of Aggregates by Use of Sodium Sulfate or Magnesium Sulfate

    C117 Test Method for Materials Finer than 75-m (No. 200) Sieve in Mineral Aggregates by Washing

    C123 Test Method for Lightweight Particles in Aggregate

    C128 Test Method for Density, Relative Density (Specific Gravity), and Absorption of Fine Aggregate

    C136 Test Method for Sieve Analysis of Fine and Coarse Aggregates

    C142 Test Method for Clay Lumps and Friable Particles in Aggregates

    C270 Specification for Mortar for Unit Masonry

    C404 Specification for Aggregates for Masonry Grout

    D75 Practice for Sampling Aggregates