ASTM C1002 - 20 Standard Specification for Steel Self-Piercing Tapping Screws for Application of Gypsum Panel Products or Metal Plaster Bases to Wood Studs or Steel Studs

    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    C645 Standard Specification for Nonstructural Steel Framing Members

    C840 Standard Specification for Application and Finishing of Gypsum Board

    C841 Standard Specification for Installation of Interior Lathing and Furring

    C844 Standard Specification for Application of Gypsum Base to Receive Gypsum Veneer Plaster

    C1280 Standard Specification for Application of Exterior Gypsum Panel Products for Use as Sheathing

    C1861 Standard Specification for Lathing and Furring Accessories, and Fasteners, for Interior and Exterior Portland Cement-Based Plaster

    E2634 Standard Specification for Flat Wall Insulating Concrete Form (ICF) Systems

    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    A510/A510M Specification for General Requirements for Wire Rods and Coarse Round Wire, Carbon Steel, and Alloy Steel

    A1040 Guide for Specifying Harmonized Standard Grade Compositions for Wrought Carbon, Low-Alloy, and Alloy Steels

    C11 Terminology Relating to Gypsum and Related Building Materials and Systems

    C475/C475M Specification for Joint Compound and Joint Tape for Finishing Gypsum Board

    C645 Specification for Nonstructural Steel Framing Members

    C847 Specification for Metal Lath

    C1396/C1396M Specification for Gypsum Board