Products and Services / Standards & Publications / Standards Products

    Standards Related to D6779 - D6779

    D5204-19

    Standard Classification System and Basis for Specification for Polyamide-Imide (PAI) Molding and Extrusion Materials

    Also Available in these Collections:

    Developed By: Committee D20 on Plastics

    D7292-18

    Standard Specification for Extruded, Compression-Molded, and Injection-Molded Basic Shapes of Polyamide-Imide (PAI)

    Also Available in these Collections:

    Developed By: Committee D20 on Plastics

    D789-19

    Standard Test Method for Determination of Relative Viscosity of Concentrated Polyamide (PA) Solutions

    Also Available in these Collections:

    Developed By: Committee D20 on Plastics

    F2785-20e1

    Standard Specification for Polyamide 12 Gas Pressure Pipe, Tubing, and Fittings

    Also Available in these Collections:

    Developed By: Committee F17 on Plastic Piping Systems

    F2600-09(2018)

    Standard Specification for Electrofusion Type Polyamide-11 Fittings for Outside Diameter Controlled Polyamide-11 Pipe and Tubing

    Also Available in these Collections:

    Developed By: Committee F17 on Plastic Piping Systems

    F2767-18

    Standard Specification for Electrofusion Type Polyamide-12 Fittings for Outside Diameter Controlled Polyamide-12 Pipe and Tubing for Gas Distribution

    Also Available in these Collections:

    Developed By: Committee F17 on Plastic Piping Systems

    D4703-16

    Standard Practice for Compression Molding Thermoplastic Materials into Test Specimens, Plaques, or Sheets

    Also Available in these Collections:

    Developed By: Committee D20 on Plastics

    D3641-15

    Standard Practice for Injection Molding Test Specimens of Thermoplastic Molding and Extrusion Materials

    Also Available in these Collections:

    Developed By: Committee D20 on Plastics

    D5740-18

    Standard Guide for Writing Material Standards in the Classification Format

    Also Available in these Collections:

    Developed By: Committee D20 on Plastics