Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM G99-04

Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus

Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus G0099-04 ASTM|G0099-04|en-US Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus Standard new BOS Vol. 03.02 Committee G02
$ 75.00 In stock

Scope

1.1 This test method describes a laboratory procedure for determining the wear of materials during sliding using a pin-on-disk apparatus. Materials are tested in pairs under nominally non-abrasive conditions. The principal areas of experimental attention in using this type of apparatus to measure wear are described. The coefficient of friction may also be determined.

1.2 The values stated in SI units are to be regarded as standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 03.02
Developed by Subcommittee: G02.40
Pages: 5
DOI: 10.1520/G0099-04
ICS Code: 17.040.20