SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|5||$54.00||  ADD TO CART|
1.1 This practice covers determination of the effect of fungi on the properties of synthetic polymeric materials in the form of molded and fabricated articles, tubes, rods, sheets, and film materials. Changes in optical, mechanical, and electrical properties may be determined by the applicable ASTM methods.
1.2 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D149 Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies
D150 Test Methods for AC Loss Characteristics and Permittivity (Dielectric Constant) of Solid Electrical Insulation
D257 Test Methods for DC Resistance or Conductance of Insulating Materials
D495 Test Method for High-Voltage, Low-Current, Dry Arc Resistance of Solid Electrical Insulation
D618 Practice for Conditioning Plastics for Testing
D638 Test Method for Tensile Properties of Plastics
D747 Test Method for Apparent Bending Modulus of Plastics by Means of a Cantilever Beam
D785 Test Method for Rockwell Hardness of Plastics and Electrical Insulating Materials
D882 Test Method for Tensile Properties of Thin Plastic Sheeting
D1003 Test Method for Haze and Luminous Transmittance of Transparent Plastics
D1708 Test Method for Tensile Properties of Plastics by Use of Microtensile Specimens
E96/E96M Test Methods for Water Vapor Transmission of Materials
E308 Practice for Computing the Colors of Objects by Using the CIE System
TAPPI StandardTest Method T 451-CM-484 Flexural Properties of Paper Available from Technical Association of the Pulp and Paper Industry (TAPPI), 15 Technology Parkway South, Norcross, GA 30092, http://www.tappi.org.
Federal StandardsFED STD 191 Method 5204 Stiffness of Cloth, Directional; Self Weighted Cantilever Method Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://dodssp.daps.dla.mil. FED STD 191 Method 5206 Stiffness of Cloth Drape and Flex; Cantilever Bending Method
ICS Number Code 23.100.60 (Filters, seals and contamination of fluids); 73.080 (Non-metalliferous minerals); 83.080.01 (Plastics in general)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM G21-09, Standard Practice for Determining Resistance of Synthetic Polymeric Materials to Fungi, ASTM International, West Conshohocken, PA, 2009, www.astm.orgBack to Top