Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM F987-04

Standard Specification for Portable Intermediate Flush Deck Stanchion

Standard Specification for Portable Intermediate Flush Deck Stanchion F0987-04 ASTM|F0987-04|en-US Standard Specification for Portable Intermediate Flush Deck Stanchion Standard new BOS Vol. 01.07 Committee F25
$ 66.00 In stock

Abstract

This specification covers the design, construction, and installation details of two-course (Type I) and three-course (Type II) portable intermediate flush deck stanchions that are used on interior and exterior decks to provide temporary protection and minimize the danger of personnel falling overboard or to a lower level in the ship in areas where the installation of a fixed system would interfere with vessel operations. This specification does not include the requirements for the chain or wire rope lines to be supported by the stanchion. The stanchions shall be free of weld spatters, slag splinters, sharp edges, burrs, projections, and other defects hazardous to personnel, and the deck sockets shall be hammer tested for soundness and strength.

Scope

1.1 This specification covers the design, construction, and installation of intermediate portable flush deck stanchions. Intermediate stanchion is defined as any stanchion that is not an end or corner stanchion.

1.2 Stanchions shall be used on interior and exterior decks, to provide temporary protection to minimize the danger of personnel falling overboard or to a lower level in the ship in areas where the installation of a fixed system would interfere with vessel operations.

1.3 Stanchions may be used with 3/8-in. (9.5-mm) galvanized close link chain or wire rope lifelines 9/16-in. (14-mm) top course, 7/16-in. (11-mm) lower courses.

1.4 This specification covers only the stanchions and does not cover requirements for the chain or wire rope lines to be supported by the stanchion.

1.5 The values stated in inch-pound units are to be regarded as the standard.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 01.07
Developed by Subcommittee: F25.03
Pages: 4
DOI: 10.1520/F0987-04