Standard Historical Last Updated: Jun 06, 2017 Track Document
ASTM F73-96(2013)

Standard Specification for Tungsten-Rhenium Alloy Wire for Electron Devices and Lamps

Standard Specification for Tungsten-Rhenium Alloy Wire for Electron Devices and Lamps F0073-96R13 ASTM|F0073-96R13|en-US Standard Specification for Tungsten-Rhenium Alloy Wire for Electron Devices and Lamps Standard new BOS Vol. 10.04 Committee F01
$ 66.00 In stock

Abstract

This specification covers tungsten-rhenium alloy wire suitable for use in electron devices and lamps. The material is known as UNS R07031. This wire shall conform to the requirements as to chemical composition prescribed. The wire shall be furnished in the following finishes: Finish 1; Finish 2; Finish 3; Finish 4; and Finish 5. The following test methods shall be performed to conform with the specified requirements: chemical analysis; tensile strength; ductility; visual inspection; and dimensional measurements.

Scope

1.1 This specification covers tungsten-rhenium alloy wire suitable for use in electron devices and lamps. The material is known as UNS R07031.

1.2 The term wire as used in this specification applies to all material 0.020 in. (0.51 mm) or less in diameter that is spooled or coiled.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 10.04
Developed by Subcommittee: F01.03
Pages: 3
DOI: 10.1520/F0073-96R13
ICS Code: 29.060.10