Standard Historical Last Updated: Nov 05, 2018 Track Document
ASTM F38-00(2014)

Standard Test Methods for Creep Relaxation of a Gasket Material

Standard Test Methods for Creep Relaxation of a Gasket Material F0038-00R14 ASTM|F0038-00R14|en-US Standard Test Methods for Creep Relaxation of a Gasket Material Standard new BOS Vol. 09.02 Committee F03
$ 75.00 In stock

Significance and Use

4.1 These test methods are designed to compare related materials under controlled conditions and their ability to maintain a given compressive stress as a function of time. A portion of the torque loss on the bolted flange is a result of creep relaxation. Torque loss can also be caused by elongation of the bolts, distortion of the flanges, and vibration; therefore, the results obtained should be correlated with field results. These test methods may be used as a routine test when agreed upon between the consumer and the producer.

Note 1Test Method B was developed using asbestos gasket materials and at issuance substantiating data were not available for other gasket materials.

Scope

1.1 These test methods provide a means of measuring the amount of creep relaxation of a gasket material at a predetermined time after a compressive stress has been applied.

1.1.1 Test Method A—Creep relaxation measured by means of a calibrated strain gauge on a bolt.

1.1.2 Test Method B—Creep relaxation measured by means of a calibrated bolt with dial indicator.

1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 09.02
Developed by Subcommittee: F03.20
Pages: 9
DOI: 10.1520/F0038-00R14
ICS Code: 23.100.60; 73.080