ASTM F2913-11

    Standard Test Method for Measuring the Coefficient of Friction for Evaluation of Slip Performance of Footwear and Test Surfaces/Flooring Using a Whole Shoe Tester


      Format Pages Price  
    PDF 10 $58.00   ADD TO CART


    1. Scope

    1.1 This test method determines the dynamic coefficient of friction between footwear and floorings under reproducible laboratory conditions for evaluating relative slip performance. The method is applicable to all types of footwear, outsole units, heel top-pieces (top-lifts) and sheet soling materials, also to most types of indoor floorings, including matting and stair nosing, and surface contaminants on the flooring surface, including but not limited to liquid water, ice, oil and grease. The method may also be applied to surfaces such as block pavers, turf and gravel.

    1.2 Special purpose footwear or fittings containing spikes, metal studs or similar may be tested on appropriate surfaces but the method does not fully take account of the risk of tripping due to footwear/ground interlock.

    1.3 The values stated in the ASTM test method in metrics are to be regarded as the standard. The values in parentheses are for information.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods

    E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

    F1646 Terminology Relating to Walkway Safety and Footwear

    F2508 Practice for Validation, Calibration, and Certification of Walkway Tribometers Using Reference Surfaces


    ICS Code

    ICS Number Code 61.060 (Footwear); 97.150 (Non-textile floor coverings)

    UNSPSC Code

    UNSPSC Code 46181600(Safety footwear)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F2913-11

    Citation Format

    ASTM F2913-11, Standard Test Method for Measuring the Coefficient of Friction for Evaluation of Slip Performance of Footwear and Test Surfaces/Flooring Using a Whole Shoe Tester, ASTM International, West Conshohocken, PA, 2011, www.astm.org

    Back to Top