Standard Historical Last Updated: Apr 17, 2019 Track Document
ASTM F269-60(2014)

Standard Test Method for Sag of Tungsten Wire

Standard Test Method for Sag of Tungsten Wire F0269-60R14 ASTM|F0269-60R14|en-US Standard Test Method for Sag of Tungsten Wire Standard new BOS Vol. 10.04 Committee F01
$ 66.00 In stock

Abstract

This test method covers a determination of the sag properties of tungsten wire. The specimen of tungsten wire to be tested for sag shall have a clean, bright surface and should have the required length. With the aid of external heat, the test specimen shall be bent into a hairpin-shape until it reached the required distance between the ends. The formed test specimen shall be of sufficient length so that when clamped in the fixture, the exposed lengths measured from the top of the apex will be of required distance.

Scope

1.1 This test method covers a determination of the sag properties of tungsten wire 0.030 in. (0.76 mm) and over in diameter.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 10.04
Developed by Subcommittee: F01.03
Pages: 2
DOI: 10.1520/F0269-60R14
ICS Code: 29.060.10