SUPERSEDED (click for Active standard)
  | Format | Pages | Price |   |
![]() |
17 | $69.00 | ![]() |
Active (view current version of standard)
1. Scope
1.1 These test methods measure the resistance of footwear to a variety of hazards that can potentially result in injury.
1.2 These test methods may be used to test for compliance to minimum performance requirements in established safety standards.
1.2.1 By agreement between the purchaser and the supplier, or as required by established safety standards, these test methods can be used to determine any one, or all of the following: (1) impact resistance (I), (2) compression resistance (C), (3) metatarsal impact resistance (Mt), (4) resistance to electrical conductivity (Cd), (5) resistance to electric hazard (EH), (6) static dissipative performance (SD), and (7) puncture resistance (PR).
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B117 Practice for Operating Salt Spray (Fog) Apparatus
CSA Standard
CAN/CSA Z195ICS Code
ICS Number Code 13.340.50 (Leg and foot protection)
UNSPSC Code
UNSPSC Code 46181600(Safety footwear)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/F2412-11
Citation Format
ASTM F2412-11, Standard Test Methods for Foot Protection, ASTM International, West Conshohocken, PA, 2011, www.astm.org
Back to Top