Standard Historical Last Updated: Apr 15, 2013 Track Document
ASTM E935-00(2006)

Standard Test Methods for Performance of Permanent Metal Railing Systems and Rails for Buildings

Standard Test Methods for Performance of Permanent Metal Railing Systems and Rails for Buildings E0935-00R06 ASTM|E0935-00R06|en-US Standard Test Methods for Performance of Permanent Metal Railing Systems and Rails for Buildings Standard new BOS Vol. 04.11 Committee E06
$ 75.00 In stock

Significance and Use

These test methods are intended to provide information from which applicable design data can be derived for the performance of metal railing systems and rails installed and fastened to structural elements of concrete, masonry, wood, and metal as well as related products. Typical floor-mounted railings are shown in Fig. 1.


FIG. 1 Front Views of Sections of Three Typical Railing Systems

Scope

1.1 These test methods cover procedures to be followed in testing the performance of permanent metal railing systems (guard, stair, and ramp-rail systems) and rails (hand, wall, grab, and transfer rails) installed in and for agricultural, assembly, commercial, educational, industrial, institutional, recreational, and residential buildings.

1.2 These test methods are applicable to such railing systems and rails having major structural components made of metal, with their secondary components made of metal or other materials such as wood, plastic, and glass.

1.3 These test methods can be used to determine whether permanent metal railing systems and rails comply with anticipated performance requirements of the applicable specifications, codes, and standards, such as those described in Specification E 985.

1.4 Specifically, these test methods cover procedures for determining the static strength of metal railing systems and rails as structural elements when installed and fastened to concrete, masonry, wood, and metal as well as related products.

1.5 No consideration is given in these test methods to any possible deterioration of metal railing systems, rails, and connections, resulting from adverse environmental conditions. The performance of special tests covering this aspect may be desirable.

1.6 These test methods are limited to the application of concentrated loads described herein. Whenever given uniformly distributed loads are to be resisted by a railing system or rail in accordance with governing specifications, codes, and standards, the effects of such uniformly distributed loads on the member stresses shall be determined by calculation and the corresponding concentrated loads shall be given consideration during testing and data evaluation.

1.7 Should computations make it possible to provide the needed information, testing can be employed for verification.

1.8 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Note 0.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.11
Developed by Subcommittee: E06.56
Pages: 7
DOI: 10.1520/E0935-00R06
ICS Code: 91.060.30