Standard Historical Last Updated: Jul 08, 2011 Track Document
ASTM E499-95(2006)

Standard Test Methods for Leaks Using the Mass Spectrometer Leak Detector in the Detector Probe Mode

Standard Test Methods for Leaks Using the Mass Spectrometer Leak Detector in the Detector Probe Mode E0499-95R06 ASTM|E0499-95R06|en-US Standard Test Methods for Leaks Using the Mass Spectrometer Leak Detector in the Detector Probe Mode Standard new BOS Vol. 03.03 Committee E07
$ 75.00 In stock

Significance and Use

Test Method A is frequently used to test large systems and complex piping installations that can be filled with a trace gas. Helium is normally used. The test method is used to locate leaks but cannot be used to quantify except for approximation. Care must be taken to provide sufficient ventilation to prevent increasing the helium background at the test site. Results are limited by the helium background and the percentage of the leaking trace gas captured by the probe.

Test Method B is used to increase the concentration of trace gas coming through the leak by capturing it within an enclosure until the signal above the helium background can be detected. By introducing a calibrated leak into the same volume for a recorded time interval, leak rates can be measured.

Scope

1.1 These test methods cover procedures for testing and locating the sources of gas leaking at the rate of 4.5 x 10 13 mol/s (1 x 108 Std cm 3/s) or greater. The test may be conducted on any device or component across which a pressure differential of helium or other suitable tracer gas may be created, and on which the effluent side of the leak to be tested is accessible for probing with the mass spectrometer sampling probe.

1.2 Two test methods are described:

1.2.1 Test Method A - Direct probing, and

1.2.2 Test Method B - Accumulation.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 03.03
Developed by Subcommittee: E07.08
Pages: 6
DOI: 10.1520/E0499-95R06
ICS Code: 71.060.01