ASTM E2584-10

    Standard Practice for Thermal Conductivity of Materials Using a Thermal Capacitance (Slug) Calorimeter


      Format Pages Price  
    PDF 11 $62.40   ADD TO CART


    1. Scope

    1.1 This practice describes a technique for the determination of the apparent thermal conductivity, λa, of materials. It is for solid materials with apparent thermal conductivities in the approximate range 0.02 < λa < 2 W/(m·K) over the approximate temperature range between 300 K and 1100 K.

    Note 1—While the practice should also be applicable to determining the thermal conductivity of non-reactive materials, it has been found specifically useful in testing fire resistive materials that are both reactive and undergo significant dimensional changes during a high temperature exposure.

    1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    C1113 Test Method for Thermal Conductivity of Refractories by Hot Wire (Platinum Resistance Thermometer Technique)

    D2214 Test Method for Estimating the Thermal Conductivity of Leather with the Cenco-Fitch Apparatus

    E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods

    E220 Test Method for Calibration of Thermocouples By Comparison Techniques

    E230 Specification and Temperature-Electromotive Force (EMF) Tables for Standardized Thermocouples

    E457 Test Method for Measuring Heat-Transfer Rate Using a Thermal Capacitance (Slug) Calorimeter

    E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method


    ICS Code

    ICS Number Code 17.200.10 (Heat. Calorimetry)

    UNSPSC Code

    UNSPSC Code 41112201(Calorimeters)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/E2584-10

    Citation Format

    ASTM E2584-10, Standard Practice for Thermal Conductivity of Materials Using a Thermal Capacitance (Slug) Calorimeter, ASTM International, West Conshohocken, PA, 2010, www.astm.org

    Back to Top