SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|2||$54.00||  ADD TO CART|
1.1 This test method covers a procedure for rapidly deforming by impact an EIFS for evaluating the effect of such deformation.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D2794 Test Method for Resistance of Organic Coatings to the Effects of Rapid Deformation (Impact)
E631 Terminology of Building Constructions
E2110 Terminology for Exterior Insulation and Finish Systems (EIFS)
ICS Number Code 19.020 (Test conditions and procedures in general)
UNSPSC Code 30151900(Finishing materials and products)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM E2486 / E2486M-13, Standard Test Method for Impact Resistance of Class PB and PI Exterior Insulation and Finish Systems (EIFS), ASTM International, West Conshohocken, PA, 2013, www.astm.orgBack to Top