ASTM E2486-06

    Standard Test Method for Impact Resistance of Class PB and PI Exterior Insulation and Finish Systems (EIFS)


      Format Pages Price  
    PDF 2 $54.00   ADD TO CART


    1. Scope

    1.1 This test method covers a procedure for rapidly deforming by impact an EIFS for evaluating the effect of such deformation.

    1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D2794 Test Method for Resistance of Organic Coatings to the Effects of Rapid Deformation (Impact)

    E2110 Terminology for Exterior Insulation and Finish Systems (EIFS)


    ICS Code

    ICS Number Code 19.020 (Test conditions and procedures in general)

    UNSPSC Code

    UNSPSC Code 30151900(Finishing materials and products)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/E2486-06

    Citation Format

    ASTM E2486-06, Standard Test Method for Impact Resistance of Class PB and PI Exterior Insulation and Finish Systems (EIFS), ASTM International, West Conshohocken, PA, 2006, www.astm.org

    Back to Top