Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM E2209-02(2006)

Standard Test Method for Analysis of High Manganese Steel Using Atomic Emission Spectrometry

Standard Test Method for Analysis of High Manganese Steel Using Atomic Emission Spectrometry E2209-02R06 ASTM|E2209-02R06|en-US Standard Test Method for Analysis of High Manganese Steel Using Atomic Emission Spectrometry Standard new BOS Vol. 03.05 Committee E01
$ 75.00 In stock

Scope

1.1 This method provides for the analysis of high manganese steel by atomic emission spectrometry using the point-to-plane technique for the following elements in the concentration ranges shown:

ElementsConcentration Range, %
Aluminum (Al)0.02 to 0.15
Carbon (C)0.3 to 1.4
Chromium (Cr)0.25 to 2.00
Manganese (Mn)8.0 to 16.2
Molybdenum (Mo)0.03 to 2.0
Nickel (Ni)0.05 to 4.0
Phosphorus (P)0.025 to 0.06
Silicon (Si)0.25 to 1.5

Note 1—The ranges represent the actual levels at which this method was tested. These concentration ranges can be extended to higher concentrations by the use of suitable reference materials. Sulfur is not included because differences in results between laboratories exceeded acceptable limits at all analyte levels.

1.2 This test method may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 03.05
Developed by Subcommittee: E01.01
Pages: 6
DOI: 10.1520/E2209-02R06
ICS Code: 77.040.30