Standard Historical Last Updated: Jul 11, 2012 Track Document
ASTM E2050-12

Standard Test Method for Determination of Total Carbon in Mold Powders by Combustion-Infrared Absorption Spectrometry

Standard Test Method for Determination of Total Carbon in Mold Powders by Combustion-Infrared Absorption Spectrometry E2050-12 ASTM|E2050-12|en-US Standard Test Method for Determination of Total Carbon in Mold Powders by Combustion-Infrared Absorption Spectrometry Standard new BOS Vol. 03.05 Committee E01
$ 66.00 In stock

Significance and Use

This test method for the determination of total carbon in mold powders is primarily intended to test such materials for compliance with compositional specifications. It is assumed that all who use this test method will be trained analysts capable of performing common laboratory procedures skillfully and safely. It is expected that the work will be performed in a properly equipped laboratory and that proper waste disposal procedures will be followed. Appropriate quality control practices must be followed such as those described in Guide E882.

Scope

1.1 This test method covers the determination of total carbon in mold powders in the concentration range from 1 % to 25 %.

Note 1—As used in this test method, percentage or % refers to a mass fraction of the form (wt / wt %) (g/100g).

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This test method has been evaluated in accordance with Practice E1601 and Guide E1763. Unless otherwise noted in the precision and bias section, the lower limit in the scope of each method specifies the lowest analyte content that may be analyzed with acceptable error (defined as a nominal 5 % risk of obtaining a 50 % or larger relative difference in results on the same test sample in two laboratories).

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 03.05
Developed by Subcommittee: E01.02
Pages: 4
DOI: 10.1520/E2050-12
ICS Code: 83.080.01