ASTM D957-95(2000)e1

    Standard Practice for Determining Surface Temperature of Molds for Plastics


      Format Pages Price  
    PDF 2 $52.00   ADD TO CART

    Active (view current version of standard)

    Other Historical Standards

    Work Item(s) - proposed revisions of this standard

    ASTM License Agreement

    More D20.09 Standards Related Products


    1. Scope

    1.1 This practice is intended for determining the temperature at a specified point or points on the surface of the cavity and base of a mold for plastics. By determining the temperature at as many points as deemed necessary, the overall temperature condition of the surface can be determined.

    1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are given for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    Note 1--There is no similar ISO standard.


    UNSPSC Code

    UNSPSC Code 13100000(Rubber and elastomers)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D0957-95R00E01

    Citation Format

    ASTM D957-95(2000)e1, Standard Practice for Determining Surface Temperature of Molds for Plastics, ASTM International, West Conshohocken, PA, 2000, www.astm.org

    Back to Top