ASTM D852-00e1

    Standard Test Method for Solidification Point of Benzene



    There is no PDF download available at this time, however you may purchase a copy of this document from the IHS Standards Store
    (Click here to view IHS phone and email contact details).



    1. Scope

    1.1 This test method covers the determination of the solidification point of benzene.

    1.2 The following applies to all specified limits in this test method: for purposes of determining conformance with this test method, an observed value or a calculated value shall be rounded off "to the nearest unit" in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 7.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1015 Test Method for Freezing Points of High-Purity Hydrocarbons

    D1016 Test Method for Purity of Hydrocarbons from Freezing Points

    D1193 Specification for Reagent Water

    D3437 Practice for Sampling and Handling Liquid Cyclic Products

    D6809 Guide for Quality Control and Quality Assurance Procedures for Aromatic Hydrocarbons and Related Materials

    E1 Specification for ASTM Liquid-in-Glass Thermometers

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

    E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method


    ICS Code

    ICS Number Code 71.080.15 (Aromatic hydrocarbons)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D0852-00E01

    Citation Format

    ASTM D852-00e1, Standard Test Method for Solidification Point of Benzene, ASTM International, West Conshohocken, PA, 2000, www.astm.org

    Back to Top