ASTM D850-03(2008)e1

    Standard Test Method for Distillation of Industrial Aromatic Hydrocarbons and Related Materials


      Format Pages Price  
    PDF 7 $60.00   ADD TO CART


    1. Scope

    1.1 This test method covers the distillation of industrial aromatic hydrocarbons and related materials of relatively narrow boiling ranges from 30 to 250°C.

    1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    1.3 The following applies to all specified limits in this test method: for the purposes of determining conformance to this test method, an observed or calculated value shall be rounded off to the nearest unit in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29.

    1.4 WarningMercury has been designated by EPA and many state agencies as a hazardous material that can cause central nervous system, kidney and liver damage. Mercury, or its vapor, may be hazardous to health and corrosive to materials. Caution should be taken when handling mercury and mercury-containing products. See the applicable product Material Safety Data Sheet (MSDS) for details and EPA's website (http://www.epa.gov/mercury/faq.htm) for additional information. Users should be aware that selling mercury or mercury-containing products, or both, in your state may be prohibited by state law.

    1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, 6.6.1and Section 7.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1078 Test Method for Distillation Range of Volatile Organic Liquids

    D3437 Practice for Sampling and Handling Liquid Cyclic Products

    D4790 Terminology of Aromatic Hydrocarbons and Related Chemicals

    D6809 Guide for Quality Control and Quality Assurance Procedures for Aromatic Hydrocarbons and Related Materials

    E1 Specification for ASTM Liquid-in-Glass Thermometers

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

    E133 Specification for Distillation Equipment

    E220 Test Method for Calibration of Thermocouples By Comparison Techniques

    E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method


    ICS Code

    ICS Number Code 75.140 (Waxes, bituminous materials and other petroleum products)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D0850-03R08E01

    Citation Format

    ASTM D850-03(2008)e1, Standard Test Method for Distillation of Industrial Aromatic Hydrocarbons and Related Materials, ASTM International, West Conshohocken, PA, 2008, www.astm.org

    Back to Top