SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|8||$60.00||  ADD TO CART|
1.1 Five practices are given for preparing films of uniform thickness of coatings on test panels. These practices are:
Practice A—Automatic Spray Machine Application
Practice B—Motor-Driven Dip Coater Application
Practice C—Motor-Driven Blade Film Application
Practice D—Hand-Held Spray Gun Application
Practice E—Hand-Held Blade Film Application
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D609 Practice for Preparation of Cold-Rolled Steel Panels for Testing Paint, Varnish, Conversion Coatings, and Related Coating Products
D1005 Test Method for Measurement of Dry-Film Thickness of Organic Coatings Using Micrometers
D1212 Test Methods for Measurement of Wet Film Thickness of Organic Coatings
D3924 Specification for Standard Environment for Conditioning and Testing Paint, Varnish, Lacquer, and Related Materials
D4147 Practice for Applying Coil Coatings Using Wire-Wound Drawdown Bars
D4285 Test Method for Indicating Oil or Water in Compressed Air
D4414 Practice for Measurement of Wet Film Thickness by Notch Gages
D7091 Practice for Nondestructive Measurement of Dry Film Thickness of Nonmagnetic Coatings Applied to Ferrous Metals and Nonmagnetic, Nonconductive Coatings Applied to Non-Ferrous Metals
ICS Number Code 87.040 (Paints and varnishes)
UNSPSC Code 31210000(Paints and primers and finishes)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D823-17, Standard Practices for Producing Films of Uniform Thickness of Paint, Varnish, and Related Products on Test Panels, ASTM International, West Conshohocken, PA, 2017, www.astm.orgBack to Top