Standard Historical Last Updated: May 13, 2016 Track Document
ASTM D7715-12

Standard Specification for Fully-Formulated Glycerin Base Engine Coolant for Heavy-Duty Engines

Standard Specification for Fully-Formulated Glycerin Base Engine Coolant for Heavy-Duty Engines D7715-12 ASTM|D7715-12|en-US Standard Specification for Fully-Formulated Glycerin Base Engine Coolant for Heavy-Duty Engines Standard new BOS Vol. 15.05 Committee D15
$ 75.00 In stock

Abstract

This specification covers the requirements for fully-formulated glycerin base coolants for cooling systems of heavy-duty engines. It also notes that the requirements of the coolant concentrate or prediluted coolant include protection in operating engines against cavitation corrosion and scaling of internal engine hot surfaces.

Scope

1.1 This specification covers the requirements for fully-formulated glycerin base coolants for cooling systems of heavy-duty engines. When concentrates are used at 40 to 60 % glycerin concentration by volume in water of suitable quality (see Appendix X1), or when prediluted glycerin base engine coolants (50 volume % min) are used without further dilution, they will function effectively during both winter and summer to provide protection against corrosion, cavitation, freezing, and boiling.

1.2 This specification is intended to cover the requirements for engine coolants prepared from virgin glycerin.

Note 1—This specification is based on the knowledge of the performance of engine coolants prepared from new or virgin ingredients that comply with Specification D7714.

1.3 The coolants governed by this specification are categorized as follows:

Coolant Type Description
V-FF Glycerin base concentrate
VI-FF Glycerin predilute (50 vol %)

1.4 Coolant concentrates meeting this specification do not require addition of supplemental coolant additive (SCA) until the first maintenance interval when a maintenance dose of SCA is required to continue protection in certain heavy duty engine cooling systems, particularly those of the wet cylinder liner-in-block design. The SCA additions are defined by and are the primary responsibility of the engine manufacturer or vehicle manufacturer. If they provide no instructions, follow the SCA supplier's instructions.

1.5 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 15.05
Developed by Subcommittee: D15.93
Pages: 5
DOI: 10.1520/D7715-12
ICS Code: 71.100.45