ASTM D7300-11

    Standard Test Method for Laboratory Determination of Strength Properties of Frozen Soil at a Constant Rate of Strain


      Format Pages Price  
    PDF 7 $60.00   ADD TO CART


    1. Scope

    1.1 This test method covers the determination of the strength behavior of cylindrical specimens of frozen soil, subjected to uniaxial compression under controlled rates of strain. It specifies the apparatus, instrumentation, and procedures for determining the stress-strain-time, or strength versus strain rate relationships for frozen soils under deviatoric creep conditions.

    1.2 Values stated in SI units are to be regarded as the standard.

    1.3 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.

    1.3.1 For the purposes of comparing measured or calculated value(s) with specified limits, the measured or calculated value(s) shall be rounded to the nearest decimal or significant digits in the specified limits.

    1.3.2 The procedures used to specify how data are collected/recorded or calculated, in this standard are regarded as the industry standard. In addition, they are representative of the significant digits that generally should be retained. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the users objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations. It is beyond the scope of this standard to consider significant digits used in analytical methods for engineering design.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D653 Terminology Relating to Soil, Rock, and Contained Fluids

    D3740 Practice for Minimum Requirements for Agencies Engaged in Testing and/or Inspection of Soil and Rock as Used in Engineering Design and Construction

    D4083 Practice for Description of Frozen Soils (Visual-Manual Procedure)

    D6026 Practice for Using Significant Digits in Geotechnical Data


    ICS Code

    ICS Number Code 13.080.99 (Other standards related to soil quality)

    UNSPSC Code

    UNSPSC Code 11111501(Soil)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D7300-11

    Citation Format

    ASTM D7300-11, Standard Test Method for Laboratory Determination of Strength Properties of Frozen Soil at a Constant Rate of Strain, ASTM International, West Conshohocken, PA, 2011, www.astm.org

    Back to Top