If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM D7041-04

    Standard Test Method for Determination of Total Sulfur in Light Hydrocarbons, Motor Fuels, and Oils by Online Gas Chromatography with Flame Photometric Detection


      Format Pages Price  
    PDF 5 $62.00   ADD TO CART


    1. Scope

    1.1 This test method covers the determination of total sulfur in liquid hydrocarbons with a final boiling point less than 450°C by gas chromatography using a flame photometric detector.

    1.2 This test method is applicable for total sulfur levels from 0.5 to 100 mg S/kg.

    Note 1—The pooled limit of quantification (PLOQ) derived from the 2002 interlaboratory cooperative test program was determined to be 1 mgS/kg.

    Note 2—Samples can also be tested at other total sulfur levels, but the precision statements may not apply.

    1.3 The values stated in SI units are to be regarded as standard.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements see Section 7.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1298 Test Method for Density, Relative Density, or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method

    D4052 Test Method for Density, Relative Density, and API Gravity of Liquids by Digital Density Meter

    D4057 Practice for Manual Sampling of Petroleum and Petroleum Products

    D4177 Practice for Automatic Sampling of Petroleum and Petroleum Products

    E840 Practice for Using Flame Photometric Detectors in Gas Chromatography


    ICS Code

    ICS Number Code 75.160.20 (Liquid fuels)

    UNSPSC Code

    UNSPSC Code 15101500(Petroleum and distillates)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D7041-04

    Citation Format

    ASTM D7041-04, Standard Test Method for Determination of Total Sulfur in Light Hydrocarbons, Motor Fuels, and Oils by Online Gas Chromatography with Flame Photometric Detection, ASTM International, West Conshohocken, PA, 2004, www.astm.org

    Back to Top