SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|3||$52.00||  ADD TO CART|
1.1 This specification defines procedures for determining the performance of certain landfill daily cover materials generally described as an alternative daily cover (ADC). This specification applies only to slurries that are sprayed, foams that are spray applied, or indigenous materials that are placed onto the working face of a Municipal Solid Waste Landfill (MSWLF) unit as a cover. It is not applicable to other types of landfills. It does not apply to geosynthetics used as an ADC.
1.2 This standard addresses the evaluation of an ADC and its ability to control fires and odors and whether or not the cover contains materials that present a threat to human health and the environment. The control of disease vectors and blowing litter can be evaluated by observation, and scavenging is controlled by security procedures and other operating practices.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D4982 Test Methods for Flammability Potential Screening Analysis of Waste
D6523 Guide for Evaluation and Selection of Alternative Daily Covers (ADCs) for Sanitary Landfills
E96/E96M Test Methods for Water Vapor Transmission of Materials
G40 Terminology Relating to Wear and Erosion
Other DocumentsEPA Method 1311 Toxicity Characteristic Leaching Procedure EPA Method 1312 Synthetic Precipitation Leaching Procedure EPA Method 8260 EPA Publication SW-846
ICS Number Code 13.030.10 (Solid wastes); 83.140.01 (Rubber and plastic products in general)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D6826-02, Standard Specification for Sprayed Slurries, Foams and Indigenous Materials Used As Alternative Daily Cover for Municipal Solid Waste Landfills, ASTM International, West Conshohocken, PA, 2002, www.astm.orgBack to Top