ASTM D609-00(2012)

    Standard Practice for Preparation of Cold-Rolled Steel Panels for Testing Paint, Varnish, Conversion Coatings, and Related Coating Products


      Format Pages Price  
    PDF 3 $52.00   ADD TO CART


    1. Scope

    1.1 This practice covers various types of cold rolled steel panels and the procedures to be followed in their preparation for testing paint, varnish, lacquer, conversion coatings, and related products.

    1.2 The procedures are as follows:
    Procedure A—Conversion coatings (phosphates, chromates,
     etc.)
    Procedure B—Vapor degreasing
    Procedure C—Solvent brushing
    Procedure D—Solvent wiping
    Procedure E—Alkaline cleaning

    1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    1.4 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A109/A109M Specification for Steel, Strip, Carbon (0.25 Maximum Percent), Cold-Rolled

    A1008/A1008M Specification for Steel, Sheet, Cold-Rolled, Carbon, Structural, High-Strength Low-Alloy, High-Strength Low-Alloy with Improved Formability, Solution Hardened, and Bake Hardenable

    D235 Specification for Mineral Spirits (Petroleum Spirits) (Hydrocarbon Dry Cleaning Solvent)


    ICS Code

    ICS Number Code 77.140.50 (Flat steel products and semi-products)

    UNSPSC Code

    UNSPSC Code 46181533(Protective coats)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D0609-00R12

    Citation Format

    ASTM D609-00(2012), Standard Practice for Preparation of Cold-Rolled Steel Panels for Testing Paint, Varnish, Conversion Coatings, and Related Coating Products, ASTM International, West Conshohocken, PA, 2012, www.astm.org

    Back to Top