ASTM D6-95(2000)e1

    Standard Test Method for Loss on Heating of Oil and Asphaltic Compounds


      Format Pages Price  
    PDF 3 $52.00   ADD TO CART


    1. Scope

    1.1 This test method covers the determination of the loss in mass (exclusive of water) of oil and asphaltic compounds when heated as hereinafter prescribed.

    1.2 The values in inch-pound units are to be regarded as standard. The values in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability and regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D5 Test Method for Penetration of Bituminous Materials

    E1 Specification for ASTM Liquid-in-Glass Thermometers

    E145 Specification for Gravity-Convection and Forced-Ventilation Ovens


    ICS Code

    ICS Number Code 91.100.50 (Binders. Sealing materials); 93.080.20 (Road construction materials)

    UNSPSC Code

    UNSPSC Code 30121601(Asphalt)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D0006-95R00E01

    Citation Format

    ASTM D6-95(2000)e1, Standard Test Method for Loss on Heating of Oil and Asphaltic Compounds, ASTM International, West Conshohocken, PA, 2000, www.astm.org

    Back to Top