ASTM D580-99

    Standard Specification for Greige Woven Glass Tapes and Webbings


      Format Pages Price  
    PDF 7 $60.00   ADD TO CART


    1. Scope

    1.1 This specification primarily covers greige tapes and webbings woven from "E" electrical classification glass fiber yarns. This specification can also be applied to tapes and webbings made of other glass fiber grades upon agreement between the purchaser and the supplier.

    1.2 This specification is intended to assist ultimate users by designating the types of these products that are typical in the industry. This specification permits the application of organic materials to the glass fiber yarn during manufacture that helps facilitate weaving. When used as permitted in this specification, such materials will not interfere with the intended end use requirements.

    1.3 This specification shows the values in both SI and inch-pound units. "SI" units is the technically correct name for the system of metric units known as the International System of Units. "Inch-pound" units is the technically correct name for the customary units used in the United States. The values stated in inch-pound units are to be regarded as the standard. The values in SI units are provided as information only.

    Note 1-This specification is one of a series to provide a substitute for the following Military Specifications: MIL-Y-1140H Yarn, Cord, Sleeving, Cloth, and Tape-Glass MIL-C-9084C Cloth, Glass Finished for Resin Laminates

    1.4 The following precautionary caveat pertain only to the test methods portions, Sections 26 through 41, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D123 Terminology Relating to Textiles

    D578 Specification for Glass Fiber Strands

    D579 Specification for Greige Woven Glass Fabrics

    D1059 Test Method for Yarn Number Based on Short-Length Specimens

    D1423 Test Method for Twist in Yarns by the Direct-Counting Method

    D1776 Practice for Conditioning Textiles for Testing

    D1777 Test Method for Thickness of Textile Materials

    D3773 Test Methods for Length of Woven Fabric

    D3774 Test Methods for Width of Woven Fabric

    D3775 Test Method for Fabric Count of Woven Fabric

    D3776 Test Methods for Mass per Unit Area (Weight) of Woven Fabric

    D4029 Specification for Finished Woven Glass Fabrics

    D4963 Test Method for Ignition Loss of Glass Strands and Fabrics

    D5035 Test Method for Breaking Strength and Elongation of Textile Fabrics (Strip Method)

    D7018 Terminology Relating to Glass Fiber and Its Products

    ANSI Standard

    ANSI/ASQC Z1.9 Sampling Procedures and Tables for Inspection Variables for Percent Nonconforming


    ICS Code

    ICS Number Code 59.100.10 (Textile glass materials)

    UNSPSC Code

    UNSPSC Code 11162125(Webbing fabrics)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D0580-99

    Citation Format

    ASTM D580-99, Standard Specification for Greige Woven Glass Tapes and Webbings, ASTM International, West Conshohocken, PA, 1999, www.astm.org

    Back to Top