ASTM D5781-95(2000)

    Standard Guide for Use of Dual-Wall Reverse-Circulation Drilling for Geoenvironmental Exploration and the Installation of Subsurface Water-Quality Monitoring Devices


      Format Pages Price  
    PDF 8 $60.00   ADD TO CART


    1. Scope

    1.1 This guide covers how dual-wall reverse-circulation drilling may be used for geoenvironmental exploration and installation of subsurface water-quality monitoring devices.

    Note 1--The term reverse circulation with respect to dual-wall drilling in this guide indicates that the circulating fluid is forced down the annular space between the double-wall drill pipe and transports soil and rock particles to the surface through the inner pipe.

    Note 2--This guide does not include considerations for geotechnical site characterizations that are addressed in a separate guide.

    1.2 Dual-wall reverse-circulation for geoenvironmental exploration and monitoring-device installations will often involve safety planning, administration, and documentation. This guide does not purport to specifically address exploration and site safety.

    1.3 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    1.5 This guide offers an organized collection of information or a series of options and does not recommend a specific course of action. This document cannot replace education or experience and should be used in conjunction with professional judgment. Not all aspects of this guide may be applicable in all circumstances. This ASTM standard is not intended to represent or replace the standard of care by which the adequacy of a given professional service must be judged, nor should this document be applied without consideration of a project's many unique aspects. The word "Standard" in the title of this document means only that the document has been approved through the ASTM consensus process.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D653 Terminology Relating to Soil, Rock, and Contained Fluids

    D1452 Practice for Soil Exploration and Sampling by Auger Borings

    D1586 Test Method for Penetration Test (SPT) and Split-Barrel Sampling of Soils

    D1587 Practice for Thin-Walled Tube Sampling of Soils for Geotechnical Purposes

    D2487 Practice for Classification of Soils for Engineering Purposes (Unified Soil Classification System)

    D3550 Practice for Thick Wall, Ring-Lined, Split Barrel, Drive Sampling of Soils

    D4428/D4428M Test Methods for Crosshole Seismic Testing

    D5088 Practice for Decontamination of Field Equipment Used at Waste Sites

    D5092 Practice for Design and Installation of Ground Water Monitoring Wells

    D5099 Test Methods for Rubber--Measurement of Processing Properties Using Capillary Rheometry

    D5254 Practice for Minimum Set of Data Elements to Identify a Ground-Water Site

    D5434 Guide for Field Logging of Subsurface Explorations of Soil and Rock


    ICS Code

    ICS Number Code 73.100.30 (Equipment for drilling and mine excavation)

    UNSPSC Code

    UNSPSC Code 81151902(Geophysical exploration)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D5781-95R00

    Citation Format

    ASTM D5781-95(2000), Standard Guide for Use of Dual-Wall Reverse-Circulation Drilling for Geoenvironmental Exploration and the Installation of Subsurface Water-Quality Monitoring Devices, ASTM International, West Conshohocken, PA, 2000, www.astm.org

    Back to Top