ASTM D522-93a

    Standard Test Methods for Mandrel Bend Test of Attached Organic Coatings


      Format Pages Price  
    PDF 4 $52.00   ADD TO CART


    1. Scope

    1.1 These test methods cover the determination of the resistance to cracking (flexibility) of attached organic coatings on substrates of sheet metal or rubber-type materials.

    1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D823 Practices for Producing Films of Uniform Thickness of Paint, Varnish, and Related Products on Test Panels

    D1005 Test Method for Measurement of Dry-Film Thickness of Organic Coatings Using Micrometers

    D1186 Test Methods for Nondestructive Measurement of Dry Film Thickness of Nonmagnetic Coatings Applied to a Ferrous Base

    D1400 Test Method for Nondestructive Measurement of Dry Film Thickness of Nonconductive Coatings Applied to a Nonferrous Metal Base


    UNSPSC Code

    UNSPSC Code 31211504(Coating paints)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D0522-93A

    Citation Format

    ASTM D522-93a, Standard Test Methods for Mandrel Bend Test of Attached Organic Coatings, ASTM International, West Conshohocken, PA, 2001, www.astm.org

    Back to Top