Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM D5201-97

Standard Practice for Calculating Formulation Physical Constants of Paints and Coatings

Standard Practice for Calculating Formulation Physical Constants of Paints and Coatings D5201-97 ASTM|D5201-97|en-US Standard Practice for Calculating Formulation Physical Constants of Paints and Coatings Standard new BOS Vol. 06.01 Committee D01
$ 66.00 In stock

Scope

1.1 This practice describes procedures commonly used in the paint industry to formulate paints and coating materials. It describes procedures for calculating formulation values for weight solids, volume solids, solvent content, volatile organic compound (VOC) content, and density of liquid paints and coatings. These values are calculated from basic formulation data. These calculations may be related to either as-supplied (unreduced) or as-applied (reduced) coating materials, including multicomponent types.

1.2 These calculated, formulation-based values may or may not be acceptable for VOC regulatory purposes, depending on the specific wording of the applicable regulation. Some regulations require analysis of the coating. Some rules allow the use of formulation data, however, some adjustments may be needed to the values calculated in this practice before they are used for regulatory purposes (see 4.3).

Note 1--Where required, use EPA Reference Method 24 and ASTM standards listed, or state regulatory requirements (see EPA 450/3-88-018 and 40 CFR 51.100).

1.3 For purposes of this practice, it is assumed that solvents evaporate and the materials that remain are identified as coating solids. For example, solvents are normally used to adjust viscosity for application and appearance of the coating. Other liquid materials, such as plasticizers, that are expected to be retained in the dried film to affect the final physical properties should be classified as part of the coating solids. Standards such as Test Methods D2369, D4758 and Guide D2832 may be used to determine volatile or nonvolatile content of specific components. For purposes of this practice it is assumed that the blended formulation behaves as an ideal solution with no volume change on mixing (see 6.2).

1.4 Volatile by-products of cross-linking reactions (cure volatiles) are not considered in these calculations since the object of this practice is to define paint physical constants based on formulation information. Variations in raw materials and variations in the production processes are not taken into account in these calculations.

1.5 The values shown in this method are stated in English inch-pound units as commonly used in the United States. However, they may be readily converted into SI units, if required by the user (for example, see Note 3).

1.6 The values stated in inch-pound units are to be regarded as the standard for this specific practice. The values given in parentheses are for information only.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 06.01
Developed by Subcommittee: D01.24
Pages: 4
DOI: 10.1520/D5201-97
ICS Code: 87.040